It's more for beginners of 3d printer learners .but real-life application is good to watch

Good information but way too short for what Coursera charges.

Looking for more technical aspect, but great course anyways

Educational, but lacks substance and a bit repetitive

good course but try to add some technical content .

the course wasn't as professional as I expected!

N​eeds updating, otherwise ok, easy to follow

good introduction to 3D printing

Not according what I expected

good

Assignments are interesting and you fell the enthusiasm of the team. However, whole course is interviews only, no slides, nothing in writing (I am quite a visual type of learner, therefore bad for me). Each of probably more than 30-40 videos has the same title strip and the same trailer at the end, together more than a minute so that you waste around 40 minutes of your time seeing the same (marketing material for their university and lab). Furthermore technology does not work well. videos repeat and repeat unless you go back to course overview and select the next one.

Some of the quizzes show up before the videos, so that I was wondering why i could only guess to answer some of the questions, later realizing that answers were given in the following videos.

Some of the quiz questions really strange and not fully covered in videos (and see above, no slide or anything you could use to resume what you should have learned)

TO SUMMARIZE - REALLY EXCITING CONTENT BUT COURSE NEEDS SIGNIFICANT IMPROVEMENT

I didn't really care about the stories from the students or seeing the space for one whole lecture video. It's clear that Ultimaker is the sponsor, but it felt like a commercial. I want to learn more.

Good over view of technology, good list of references and resources to explore more on your own. Didn't really need to be 2 "weeks" worth. Audit for the info.

Great for someone who knows nothing about 3d printing, but overly simplistic if you have any concept of whats going on in that space.

Much of the information presented is outdated and unnecessarily lengthy.

More of a promotional course than a learning course. You could learn most of the content here by finding a good news article. Videos are short and slow, if you took out the intro to each video and play them at 1.25 speed(as to not fall asleep). You can complete this course in 2 hours and get great scores on the quizzes.

This course doesn't contain any new information. It does not teach you but just excitedly shows commonly known facts.

There are better ways to invest your time.

Several glitches in Thingiverse. The interface the faculty shows is outdated. And there's no response from the support staff or the faculty.

in the assignment they should have not made it mandatory about uploading video

It's not a course... this is a very short general introduction to 3D Printing

I did not really learn new technical skills.